Panel joints may be caulked with pure white silicone sealant and panel edges fitted into extruded plastic moldings.
Installing white hardboard wall panel.
From an inside corner on a wall where you wish to start installing 4 foot wide panels.
Gently remove any crown moulding baseboards and trim you plan on using again.
Plan the installation to start at a left side corner and work outward across the wall to the right.
Leave the panels in this location for a minimum of 48 hours before installation to allow them to acclimate.
Measure the height of the wall where you plan to install the hardboard panels using a tape measure.
Using a level mark a plumb line 48 in.
Place the first hardboard panel up to the corner of the wall and locate a wall stud in the center of it.
Tack a full panel in place with one long edge aligned with the plumb mark then check to see how the opposite edge fits into the corner.
Thrifty white panelboard is 1 8 in.
Insert 3 4 inch nails through the stud spacing them every 8 inches.
How to install tempered hardboard panels to walls.
Measure mark and cut the beadboard.
For best results set the paneling in the room for a few days before you install it.
The first step in how to install paneling is to remove all wall plates outlets and any nails in the wall.
If the corner isn t straight and plumb you ll see gaps.
Thick x 4 ft.
This is the.
Installation is done using a high grade panel or construction trowel on adhesive.
Panel should end and begin on a stud.
Who says you can t draw on the walls.
In a conventionally framed room with wall studs 16 on center each 4x8 ft.
For other options like our thrifty white smooth paneling you can quickly brighten up utility and laundry rooms.
When installing hardboard on the ceiling secure it firmly to the joists to prevent sagging.
Stack the hardboard panels in the room where you plan to install them and leave them for 48 hours to allow them to acclimate.
With our markerboard and frost white panels you can add a functional wall to draw and color on such as in workshops and playrooms.
After attaching the panel to the center stud insert additional nails through all remaining studs in the same manner.
Step 1 move the hardboard panels into the installation room and lean them up against the wall with the backs facing outward toward the room.