How To Tar Paper And Shingle A Roof

Place a final piece of tar paper over the top of the roof attaching it so it overlaps the tar paper on both sides of the roof.

How to tar paper and shingle a roof.

This is how i paper my vallies. Sometimes called roofing felt underlayment roofing tar paper or roll roofing this is a layer of protection installed between the roof deck and the roofing shingles. I swear it is the fastest way out there. The idea is to make sure water that falls on the roof drips down from paper to paper and off the roof rather than up under the tar paper potentially damaging the roof s wooden structure.

Felt paper and synthetic. Once the tar is applied tar paper can be carefully placed on top of the hot tar using a mop to sink the paper into the asphalt. The felt provides a layer of additional weather protection between the roofing finishing material shingles tiles and the roof decking. Lay the first course of tar paper lengthwise on the roof so one edge is covering the drip edge nailed to the roof.

Then i run a r. In our industry there are two main varieties of underlayment. What is roofing paper or felt. Make at least three layers.

Also called roof felt or builder s felt overlapped tar paper creates a water barrier that is your home s last line of defense against the elements if your shingles are damaged by wind hail or age. Felt paper also called tar paper or builder s paper helps shed water that gets under the shingles protects the asphalt shingles from the resins in the wood decking increases a roof s fire rating and helps keep your house dry if it rains during the job. Roofing felt is comprised of a base made from natural materials such as wood cellulose or synthetic ones such as fiberglass or polyester and then coated or saturated with a. The black rolls of roof paper or felt are made with asphalt and are normally available in rolls.

Overlapping the tar paper layers to create a seal. It was easy to use durable and even had alignment lines to help with the shingle installation. Take a close look at how i paper the 30 in the center of the valley. It s raining and there is water leaking inside your home.

Felt paper also referred to as tar paper was the standard underlayment material in roofing for decades. Staple it to the plywood with a staple gun placing the staples at 6 to 8 inch intervals along the edges and in the middle of the paper. Unroll the paper on the roof and cut it to the correct length with a utility knife. Experienced professionals never allow the hot tar to clump up or build up in any area.